Huang's CNC m4 RIS

[spartan117]

Does anyone if the item listed below fits m4's other than TM/JG such as G&G, CA, or G&P? I've heard that the JG/TM handguards are slightly shorter than the other brands. So again, does it fit G&G's, CA, or G&P's?

Link to item:
http://www.dragonredairsoft.com/airs...roductID=22570

[Karma_]

Apparently it will. I ordered one and should have it early next week so I can give you a definite answer then if no one else knows.

[spartan117]

Originally Posted by Karma_

Apparently it will. I ordered one and should have it early next week so I can give you a definite answer then if no one else knows.

Alright! Thanks!

[HaloSix4]

If you want one for a CA just get a CA RIS http://airsoftglobal.com/product_inf...oducts_id=4633, i'm sure it fits TM/JG to.

[spartan117]

Originally Posted by Halo64

If you want one for a CA just get a CA RIS http://airsoftglobal.com/product_inf...oducts_id=4633, i'm sure it fits TM/JG to.

Does it line up properly with other brands of m4 upper receivers? I 've heard that the rails on the top of a ca 15a4 is slightly elevated compared to others.

[HaloSix4]

i have not had a problem on my TM, I am also buying another one for my JG M4.

[huang]

It fits G&P, G&G , Dboy and any M4 that actullay use the same length of the real steel RIS. It doesn't fit Jinggong, TM( they use a shorter toy version RIS ) unless you change the front cap and outer barrel.

[Karma_]

And just a heads up, the CA rails are a bit higher than other guns. You heard right Spartan.

[Karma_]

Alright Spartan, I put the rail on my gun today. I'm actually really happy with it. I had to remove the front sight in order to get it on but luckily I had it off to remove a different rail. It took a few little taps with a hammer to get it on but now that it's on, it is tight and doesn't wiggle. You may have the same issues or not. I put it on a PTW. If you have anymore questions, shoot me a PM.

[spartan117]

thanks Karma!