I wanna upgrade my CA M24 socom sniper

[T@NK]

hey guys, dont laugh at me since i m a noob...i wanna upgrade my CA M24 socom sniper from 315fps to 460fps. what accessories/parts do i need except the spring in order to keep my gun stable? thx a lot.

[Ghillie973]

Well you'll need a:

-piston w/ piston head
-Spring guide (either 7mm or 9mm depending on your spring)

Now these are the basics but after a while you'll need a new cylinder as yours will break with the new spring. At this time you might as well get a new cylinder head too.

[CDN_Stalker]

Ghillie, I'm surprised yo udidn't point him my way! Lol ya bum!!!

From my sniper section on the team forum (all shown from the WGC site):

Originally Posted by Stalker

Here's the manual for the CA M24 V2:

http://www.classicarmy.com/showcatal...?acid=111&pg=1

Upgrading to 450fps, I'd recommend these parts (you will need an upgraded cylinder for it, not sure if stock will work with these parts):

Guarder:

Ultra-light Piston for APS2



Piston head for APS2



7mm bearing spring guide for APS2



Clear Hop Up & Bucking rubber



First Factory/Laylax:

PSS2 130SP Spring



Prometheus:

6.03mm 534mm tightbore barrel (needs to trim off about 19mm to make it fit right)



All the above is what I have in my M24 (I have a different spring though, as well as the 9mm spring guide). That spring should give you about 425fps with 0.20g BBs, the tightbore will add another 10fps, and the bearing spring guide another 15fps, bringing you around 450fps.