Pictures of your rear wired m4?

[PrIeSt]

I have a retractable stock on my m14. I am in the process of wiring the battery to the back, along with a trigger master etc. eventually a lipo

I am looking for anyone who can post pics of how they wired there wiresout the back of the rifles?

and possibly into the buffer tube? Thanks!!!

Shawn

[Gunny_McSmith]

I dont have picture of my wiring right now, but a useful tip would be to ''COIL'' the wires inside the buffer tube so they'll take less room inside it, and that will prevent damage on the wires = less chance of a short-circuit!

[Danke]

I just hooked up a trigger master.

Things were already rear wired to start.

I had to run the wires from the mechbox the full length of the buffer tube so I had room to thread the screw into the upper receiver that holds the buffer tube in place, then I collapsed the wires into the tube with the switch hanging just at the end of the buffer so I could plug the battery in.

[PrIeSt]

Originally Posted by Danke

I just hooked up a trigger master.

Things were already rear wired to start.

I had to run the wires from the mechbox the full length of the buffer tube so I had room to thread the screw into the upper receiver that holds the buffer tube in place, then I collapsed the wires into the tube with the switch hanging just at the end of the buffer so I could plug the battery in.

I think i will be doing something similair. I am taking my buffer tube in to work today to have the machinists drills a nice route for my wire to run along

[ybrik]

I'll post pics tonight of my m4 with a lipo in a buffer tube.

[ybrik]

G&P buffer tube and crane stock [GP416]

KA-BAT-10

Lipo and rifle both wired to deans:

Wires tucked inside the tube:

Close-up:

Crane stock still fully retracts with enough room for protruding wires: