Kings Arms metal hop up installation on TM lower?

[yanhchan]

How exectly do I install the Kings Arms metal hop up onto a TM lower reicever I understand that I will have to dremel but I'm afraid of taking too much material off can someone take a picture of their modified lower so that I can see exectly how much material I need to cut off in order to fit the metal hop up?

[ILLusion]

You just need to cut a square, where the stock hop up lower chamber screws in. Cut it to the front edge of the magwell.

[yanhchan]

Originally Posted by ILLusion

You just need to cut a square, where the stock hop up lower chamber screws in. Cut it to the front edge of the magwell.

Thank you very much!!!! Dremel would do the trick yes?

[ILLusion]

Originally Posted by yanhchan

Thank you very much!!!! Dremel would do the trick yes?

Yeah, I just used a cutting wheel and then finished off the edges with a file.