Airsoft Canada - View Single Post - Troubleshooting new build: Opinion requested!

Flarebrass · February 24th, 2014, 12:42

Hey Lurking,

No problem. Maybe if I clarified a little better it would help. When I shoot in semi, wherever the nozzle was, is where it ends up. It only changes position (middle, forward, back, etc) after I shoot in full auto then swap back to semi again. The nozzle DOES stick out a bit in its fully recoiled stage, which is probably why the bb's aren't going up into the hop up. Is there a way to stabilize it so it doesnt keep changing stages after full auto (were excluding the AB mosfet at this point as I do not want to have to rewire it and purchase a new AB mosfet if its not required)? That is what I meant by a timing type issue.

Do you have any guides in regards to taking teeth off the release side of the sector gear (as I stated above all the guides I reviewed and learnt from are saying pickup side; if that's wrong, where are the guides for the correct way haha)?

Thanks again,

Flarebrass

February 24th, 2014, 12:42	#8
Flarebrass Trader rating Join Date: Jul 2012 Location: St. Catharines, Ontario	Hey Lurking, No problem. Maybe if I clarified a little better it would help. When I shoot in semi, wherever the nozzle was, is where it ends up. It only changes position (middle, forward, back, etc) after I shoot in full auto then swap back to semi again. The nozzle DOES stick out a bit in its fully recoiled stage, which is probably why the bb's aren't going up into the hop up. Is there a way to stabilize it so it doesnt keep changing stages after full auto (were excluding the AB mosfet at this point as I do not want to have to rewire it and purchase a new AB mosfet if its not required)? That is what I meant by a timing type issue. Do you have any guides in regards to taking teeth off the release side of the sector gear (as I stated above all the guides I reviewed and learnt from are saying pickup side; if that's wrong, where are the guides for the correct way haha)? Thanks again, Flarebrass Last edited by Flarebrass; February 24th, 2014 at 12:45..