Airsoft Canada - View Single Post - Troubleshooting new build: Opinion requested!

Flarebrass · February 24th, 2014, 11:59

Hey Lurk,

That is what I did! (your first sentence differs from your second, so I am going off what i read). When I did my short stroking research, the guides I used said to take teeth off the pickup side of the sector gear and teeth off the release side of the piston. This was to omit your exact reason of messing up the tappet plate timing. The guides that I used were as follows:

http://airsofttutorials.com/tutorial...-stroking.html

http://www.airsoftsociety.com/forums...uestion-87086/

http://www.airsoftforum.com/board/lo...p/t278152.html

Are these guides incorrect in doing so? Should it be teeth removed from both the release side of the piston and the release side of the sector gear?

Thanks,

Flarebrass

February 24th, 2014, 11:59	#5
Flarebrass Trader rating Join Date: Jul 2012 Location: St. Catharines, Ontario	Hey Lurk, That is what I did! (your first sentence differs from your second, so I am going off what i read). When I did my short stroking research, the guides I used said to take teeth off the pickup side of the sector gear and teeth off the release side of the piston. This was to omit your exact reason of messing up the tappet plate timing. The guides that I used were as follows: http://airsofttutorials.com/tutorial...-stroking.html http://www.airsoftsociety.com/forums...uestion-87086/ http://www.airsoftforum.com/board/lo...p/t278152.html Are these guides incorrect in doing so? Should it be teeth removed from both the release side of the piston and the release side of the sector gear? Thanks, Flarebrass