Airsoft Canada - View Single Post

deadlydayne · July 19th, 2011, 21:48

I will probably powder coat, as I dont see much of a market for them right now.

****UPDATE ON AEG BARREL****
So I couldnt get a mill to open up so I could cut the barrel, so I got tired of waiting and grabbed my dremel. I put in one of the small endmills that came with it, measured the distance that the notches needed to be and cut it with the *side* of the endmill, NOT the Bottom. When I finished with the Dremel I used a small file to file in a 90 degree angle on the sides that needed it. Needless to say it was a quick 10 minute job. Best of all, IT WORKS!!!! I did this to my stock AEG barrel so my accuracy probably wont increase much seing as how the AEG stock barrel was a 6.11mm ID and the WE stock barrel was 6.05mm ID. Although I got another 5", so it might add in accuracy a little. I might just order myself a LONG like 600mm AEG barrel and make it a massive rifle, Idk, this kinda opens a whole new door.

July 19th, 2011, 21:48	#525
deadlydayne Trader rating Join Date: Mar 2011 Location: Michigan, USA	I will probably powder coat, as I dont see much of a market for them right now. **UPDATE ON AEG BARREL** So I couldnt get a mill to open up so I could cut the barrel, so I got tired of waiting and grabbed my dremel. I put in one of the small endmills that came with it, measured the distance that the notches needed to be and cut it with the side of the endmill, NOT the Bottom. When I finished with the Dremel I used a small file to file in a 90 degree angle on the sides that needed it. Needless to say it was a quick 10 minute job. Best of all, IT WORKS!!!! I did this to my stock AEG barrel so my accuracy probably wont increase much seing as how the AEG stock barrel was a 6.11mm ID and the WE stock barrel was 6.05mm ID. Although I got another 5", so it might add in accuracy a little. I might just order myself a LONG like 600mm AEG barrel and make it a massive rifle, Idk, this kinda opens a whole new door. Last edited by deadlydayne; July 20th, 2011 at 04:51..