Airsoft Canada - View Single Post - FAQ for Tokyo Marui Hi-Capa, 2011, 1911, MEU & Detonics type variants

RJT · June 14th, 2011, 20:56

Brian,

Thanks for the response!!

I had it chroned today and it shot as high as 285 but was around a 240 average. After I got back home I put teflon tape around the hop up area and now it shoots through both side of a drink can. I can only assume it has helped it but will need to chrono to know exactly how much.

I know it is hard to tell what is wrong without looking at it direct. If you were in US I would jusr send it to you fix.

Have any idea why the slide stop would not be working on a regular basis? It works at time and other time not. Does the safety spring play a part in it engaing? I dont think it is the mag follower spring?? I know most slide locks pop in place but this one does not. Would a weak plunger spring cause this?

It is getting a bit better day by day considering where it started from. Thanks for all the help so far.

June 14th, 2011, 20:56	#1154
RJT Trader rating Join Date: Jun 2011 Location: North Carolina	Brian, Thanks for the response!! I had it chroned today and it shot as high as 285 but was around a 240 average. After I got back home I put teflon tape around the hop up area and now it shoots through both side of a drink can. I can only assume it has helped it but will need to chrono to know exactly how much. I know it is hard to tell what is wrong without looking at it direct. If you were in US I would jusr send it to you fix. Have any idea why the slide stop would not be working on a regular basis? It works at time and other time not. Does the safety spring play a part in it engaing? I dont think it is the mag follower spring?? I know most slide locks pop in place but this one does not. Would a weak plunger spring cause this? It is getting a bit better day by day considering where it started from. Thanks for all the help so far. Last edited by RJT; June 14th, 2011 at 21:57..