Quote:
Originally Posted by simohayha
ok, found one more "problem".
after i assemble the whole gun, all mechanics are functioning, but as i pull the slide back slowly, its seems like the hammer (in cocked position) is pushing up against the lower side of the bbu (the one that allways have the paint/anodising worn out) causing excessive friction. and if i release the slide slowly, the slide would stuck with the lower side of bbu unable to pass trough the hammer.
the cycling works if i pull it fast / hard enough or just release the slide from it back most position with 150% spring pushing the slide forward.
i have a feeling that this is caused by using guarder 150% spring set and the main spring is pushing the hammer too hard.
is there any way around this or is its just easier to swap back to standard mainspring?
thanks
|
Every setup is different in that regard. The only thing that I can suggest is to try swapping different parts. Your particular combination of parts could be making this problem worse than other combinations