Airsoft Canada - View Single Post - FAQ for Tokyo Marui Hi-Capa, 2011, 1911, MEU & Detonics type variants

simohayha · April 14th, 2011, 02:41

ok, found two more "problem".
first: after i assemble the whole gun, all mechanics are functioning, but as i pull the slide back slowly, its seems like the hammer (in cocked position) is pushing up against the lower side of the bbu (the one that allways have the paint/anodising worn out) causing excessive friction. and if i release the slide slowly, the slide would stuck with the lower side of bbu unable to pass trough the hammer.
the cycling works if i pull it fast / hard enough or just release the slide from it back most position with 150% spring pushing the slide forward.
i have a feeling that this is caused by using guarder 150% spring set and the main spring is pushing the hammer too hard.
is there any way around this or is its just easier to swap back to standard mainspring?

second:the nova thumb safety can "click" into save position without the slide installed BUT cant if i install the slide, as if the triangle cut in the slide where it sits when in save is not cut high enough for the thumb safety to "click" and hold its position. now if i try to put it in safe and shake the gun, it just fell back to fire position.
thanks

April 14th, 2011, 02:41	#1024
simohayha Trader rating Join Date: Nov 2008	ok, found two more "problem". first: after i assemble the whole gun, all mechanics are functioning, but as i pull the slide back slowly, its seems like the hammer (in cocked position) is pushing up against the lower side of the bbu (the one that allways have the paint/anodising worn out) causing excessive friction. and if i release the slide slowly, the slide would stuck with the lower side of bbu unable to pass trough the hammer. the cycling works if i pull it fast / hard enough or just release the slide from it back most position with 150% spring pushing the slide forward. i have a feeling that this is caused by using guarder 150% spring set and the main spring is pushing the hammer too hard. is there any way around this or is its just easier to swap back to standard mainspring? second:the nova thumb safety can "click" into save position without the slide installed BUT cant if i install the slide, as if the triangle cut in the slide where it sits when in save is not cut high enough for the thumb safety to "click" and hold its position. now if i try to put it in safe and shake the gun, it just fell back to fire position. thanks Last edited by simohayha; April 14th, 2011 at 02:54..