Airsoft Canada - View Single Post

Mart83 · March 19th, 2011, 08:58

The way I solved my problem, just so I would not destroy the spring plug once again, is by inserting a thin rubber washer between the spring guide and the spring. Just trim what exceed the guide since washer are usually larger than it.

My gun is running very fine like this. I've encountered no problem, and the plug has stopped getting hurt inside (no marking).

But what Drake suggest is I think pretty simpler than what I've done.

March 19th, 2011, 08:58	#19
Mart83 Loves Justin Bieber ♥ Trader rating Join Date: Aug 2008 Location: St-Jerome	The way I solved my problem, just so I would not destroy the spring plug once again, is by inserting a thin rubber washer between the spring guide and the spring. Just trim what exceed the guide since washer are usually larger than it. My gun is running very fine like this. I've encountered no problem, and the plug has stopped getting hurt inside (no marking). But what Drake suggest is I think pretty simpler than what I've done. __________________ "La perfection n'existe pas, l'excellence oui" Sent from my Cyrix 486DX2-50 using mIRC 2.1a using 14.4K USRobotic dial-up modem.