Quote:
Originally Posted by ILLusion
Well... I suppose, yes, if there's currently a problem causing your nozzle to sit further away from the magazine than it should.
Is that the case? Otherwise, you could just be introducing problems or fixing problems where there aren't any. Such as the so-called plumber's tape "mod".
|
Well, it was just an idea I had... not sure if its the mag seal lip, but i will do more test..
Wanna hear something weird?
I disassembled my gun and the IK bbu piston seems to be slightly loose so i fastened it more. I was thinking maybe because it was loose, it wasn't compressing the o-ring as much, causing gas to leak out.
I switched to a stock BBU with AS nozzle and my fps seems to be back to normal. With my hop up turned up, fps went up even more.
Then i switched back to my IK BBU and SD POM nozzle and my FPS seems to be fine..
Then i got greedy, I thought that my FPS leak had to be caused by the piston head being loose. I took out the piston in the IK BBU and i wrapped a thin layer of teflon tape around the crevice where the oring goes and replaced the oring on top. My fps then dropped all the way to 100fps. I removed the thin piece of teflon again and my fps again remained at 100fps
