Airsoft Canada - View Single Post

Brakoo · October 3rd, 2010, 20:04

I just tried that and it seems to be getting stuck about midway in it's travel. That would be just before the notch on the slide to pop the slide release meets the slide release.

EDIT : I just tested it again and this time I held the hammer down as much as I could with a screwdriver and with the hammer fully pulled back it's not getting stuck other than on the initial pull but the rest of the way the slide moves freely.

October 3rd, 2010, 20:04	#3
Brakoo Trader rating Join Date: Dec 2003 Location: Laval, Quebec	I just tried that and it seems to be getting stuck about midway in it's travel. That would be just before the notch on the slide to pop the slide release meets the slide release. EDIT : I just tested it again and this time I held the hammer down as much as I could with a screwdriver and with the hammer fully pulled back it's not getting stuck other than on the initial pull but the rest of the way the slide moves freely. __________________ Last edited by Brakoo; October 3rd, 2010 at 20:10..