Airsoft Canada - View Single Post

Axemetal · July 21st, 2010, 16:35

Ok so just for a bit of info I've been rewiring my gearbox to work from the rear. and that was completed last night unfortunately while fitting the gearbox back into the gun I snapped the Fire selector plate. I have a new fire selector plate and have fully assembled the gear box again. but after getting the gear box back into the gun this time my gun wont change from safe/semi/full it stays in full the whole time. I'm very confused...HELP

The two fire selector plates are the same size. also I think it may have something to do with the way the safety switch is lining up inside the gun (not inside the gearbox) but I cant see that. Is there something I'm supposed to do to make sure the gun is lined up properly before putting the gear box back in?

July 21st, 2010, 16:35	#1
Axemetal Trader rating Join Date: May 2010 Location: Etobicoke	HELP gearbox fitting inside M4 body Ok so just for a bit of info I've been rewiring my gearbox to work from the rear. and that was completed last night unfortunately while fitting the gearbox back into the gun I snapped the Fire selector plate. I have a new fire selector plate and have fully assembled the gear box again. but after getting the gear box back into the gun this time my gun wont change from safe/semi/full it stays in full the whole time. I'm very confused...HELP The two fire selector plates are the same size. also I think it may have something to do with the way the safety switch is lining up inside the gun (not inside the gearbox) but I cant see that. Is there something I'm supposed to do to make sure the gun is lined up properly before putting the gear box back in?