Spring M4 Reassembly
 

Some pieces fell out of my body in the spring m4 when I was taking off the body so i disassembled the entire gun to pu the parts back in and fix it.

Well to make this short, I am now sitting here with a fully disassembled gun and have absolutely no idea how to reassemble it.

Could someone tell me the reassembly procedures or point me to somewhere that will.

Please respond ASAP.

Thanks

1. You didn't tell us any brand or model of the gun you have.
2. We generally don't deal with spring assault rifles because they're too shitty and cheap to bother with.

I would love to tell you the brand but it doesn't say anywhere I dont think. All I have is a brown box.

HFC XM117 Spring Rifle assembly is what I need.

A picture would help alot.

http://www.airsplat.com/Images/AR-HA-207.jpg

thats the best I can do...

It is the HFC XM117 Spring rifle. I need either a manual or assembly guide for it

Buddy, if your not 18 (like me), SHUT-UP! sit back, dont play airsoft, read some threads, make a ghillie suit, play guitar and do your homework! and wait for your time because 3-8 years will go by pretty fast. I'll reffer you to thatotherguy:
http://www.airsoftcanada.com/showthr...ou+illustrated

Maybe he can clear some fog :)

LOL, +1. hahahaha

you need to post pics
or be a very descriptive writer

This picture helps nothing. A picture of your actual gun with the the parts is what would help.

ok, what i used to do is to take a look at both halves of the body. usually you should be able to figure out which side they put the parts into before closing it up with the other side. place all the small parts into that side, saving the main spring for last. before you put the pain spring in, take some strips of electricians tape long enough to wrap around the body. take smaller strips and tape them in the middle of the longer strips (making a 'non-sticky' zone in the middle) install the spring/piston/cylinder assembly and hold it in with your hands while you use the tape to hold it down and prevent it from popping out. make sure the 'non-sticky' zones are over the spring/the inside of the body. then reassemble the other half. once its all screwed together, cut the tape and pull it out from in between the two sides.

thats the easiest way i can think of. if you cant figure out how to put her back together.... then its all over and you shouldnt have taken it apart in the first place. be ready to be frustrated over and over again. spring guns are just like that.

I am able to get the spring assembly on and stuff and get the body snapped into the proper placement. Just the trigger assembly isn't working like it should be....


attaching pictures:

http://img398.imageshack.us/my.php?image=img0108ey9.jpg

http://img179.imageshack.us/my.php?image=img0109vn8.jpg

http://img147.imageshack.us/my.php?image=img0110zs4.jpg
(Not sure if those 2 little tiny pieces are used.)
http://img147.imageshack.us/my.php?image=img0111yt0.jpg

anyone have any ideas on how to assemble the trigger area?

My question, Y did you bought a Spring assault rifle, and Again WHY did you disassemble it?
>.>

3 bbs jammed in the middle of the barrel. when i took the barrel off and pushed the bbs outta the barrel a piece from the body fell out =\

which is why i had to take apart the main body.

And im sorry if we are all not rolling in the money like you are to just go buy a AEG

Are the cheaper $150 AEGs any good? haha