PDI HOP UP problem APS Type 96
 

Hi!

There are my gun...
Maruzen APS Type 96
PDI Cylinder Set VC
PDI 6.01 Inner Barrel
PDI Hop-up Chamber
PDI Barrel Spacer Set x2
PSS96 Zero Trigger
Spring M130 if I remenber
Firefly Bucking
I use (at the moment) 0.30g Madbull Precision BB

The problem I have is the screw (of the hop up adjustment) is tighted to max and the BB still to reach the sky after 30m. That made me unable to hit a target at 50m (150 feet). :banghead:

I heard I am supose to be able to hit a target of about 1 feet square at 50m with a sniper full upgraded like this one...


Help me! What should I change or adjust?
Edit: The left/right adjustement is fine it go in straight line its just the "sky" adjustment the problem...


Other point the Inner Barrel is REALLY hard to remove or put back in the outter barrel (friction) any way to made it easier?

Bump I still need help :D

I will downgrade (again) my spring is firing at 494 fps :'( it will help the hop up.
Did I should change the bucking? What is the best bucking for my setup?

Firefly hop up rubbers are very picky about FPS ranges, soft, medium, and hard... and I believe the max range for the hard Firefly rubber is 500FPS... switch to another rubber to see if you improve your range, it can't hurt.

I have to find out the good spring to downgrade the FPS to 420-430 (less than 450) with 0.20. Firefly Rubbers are supose to be good?

Yes... i bought a few from Amos last year and I've ran them all in the 350FPS range. I'm starting to get in to the sniper platform as soon as my M28 gets here.

Do you know what you have for rubbers? Soft, medium, or hard?

I dont know I believe it's a hard one but He could be a litle bit destroy... The previous owner was shooting at 530+ fps with this gun + hop up. I will look for another hard firefly.

Contact Amos on these forums, he should be able to help you out.

Okay thank!